127 Topic(s)
You perform I/O checkout on the Multi-I/O module to verify that the devices are wired correctly and that the physical inputs and outputs are working properly.
After you have wired the physical inputs and outputs of the controller, you perform I/O checkout to verify that the wiring was done correctly and that the physical inputs and outputs are working properly.
You test the DALI relay outputs to ensure they are operating correctly.
Before you can do an I/O checkout on a DALI module, you must first perform a DALI discovery and associate the discovered physical output with logical outputs in the RP controller configuration. You then wink DALI outputs in order to identify the light or control device location when associating the physical output with the logical output.
You test the light outputs to ensure that DALI lights are operating correctly and are properly associated.
When the Relay 10 module is configured on the RP-C, you can log into the Commission mobile application and configure the following inputs and outputs:
You test the relay module relay outputs to ensure they are operating correctly
You perform I/O checkout to verify that the wiring between the devices was done correctly and to verify that the physical inputs and outputs are working properly.
You connect to a device to begin all commissioning tasks.
You perform an I/O checkout to verify that installed modules match the RP controller configuration and are communicating properly. You configure RP controller expansion modules in WorkStation.