MP-C
Refine your search
165 Topic(s)
How to
You connect to a controller to begin all commissioning tasks. Through Bluetooth, you can connect to a single controller at a time. Bluetooth connectivity is supported for the MP and RP controllers of the BACnet/IP controller family. Bluetooth connectivity is not supported for IP-IO devices. On the MP controller you connect using the SpaceLogic BLE adapter through the controller’s sensor bus and Spacelogic Sensor. With RP controllers, you connect using the onboard BLE or the BLE adapter for the EasyLogic controller models.
How to
When the Relay 10 module is configured on the RP-C, you can log into the Commission mobile application and configure the following inputs and outputs:
How to
You test the relay module relay outputs to ensure they are operating correctly
How to
You perform I/O checkout to verify that the wiring between the devices was done correctly and to verify that the physical inputs and outputs are working properly.
How to
You perform I/O checkout on the Multi-I/O module to verify that the devices are wired correctly and that the physical inputs and outputs are working properly.
Concept
After you have wired the physical inputs and outputs of the controller, you perform I/O checkout to verify that the wiring was done correctly and that the physical inputs and outputs are working properly.
How to
You test the DALI relay outputs to ensure they are operating correctly.
How to
The SpaceLogic Bluetooth Adapter allows you to establish a Bluetooth connection to SpaceLogic and EasyLogic controller models. To connect to a device through the SpaceLogic Bluetooth Adapter, a SpaceLogic Sensor must be wired to the controller.
How to
Before you can do an I/O checkout on a DALI module, you must first perform a DALI discovery and associate the discovered physical output with logical outputs in the RP controller configuration. You then wink DALI outputs in order to identify the light or control device location when associating the physical output with the logical output.
How to
You test the light outputs to ensure that DALI lights are operating correctly and are properly associated.