概念
AD v2 Communication and Power
AD v2 can use either a wired (USB) connection or a wireless (WiFi) connection to communicate with SmartStruxure servers. AD v2 can be powered either by an AS-P, AS-B, or USB power adapter, but not by an Automation Server.
Communication over a USB Connection
The preinstalled SmartX AD-Link application enables AD v2 to communicate with SmartStruxure servers over a USB connection.
When AD v2 is connected to AS-P or AS-B, AD v2 can be powered by the SmartStruxure server device through the USB cable. The screen must not be turned on constantly because this may drain the battery.
When AD v2 is connected to an Automation Server, AD v2 must be powered by a USB power adapter. The Automation Server does not provide enough power for AD v2. A USB “Y” cable allows you to connect AD v2 to two different devices, an Automation Server and a USB power adapter, to receive data and power respectively. The screen must not be turned on constantly because this may drain the battery.
Use only Samsung-approved power adapters. Using other power adapters can cause the battery to explode or damage the tablet.
警告
|
|---|
|
HAZARD OF EXPLOSION OR DEVICE DAMAGE Use only Samsung-approved power adapters. Failure to follow these instructions can result in death, serious injury, or equipment damage. |
Communication over a Wireless Connection
AD v2 can communicate with SmartStruxure servers through a wireless access point (AP), which is connected to the same network as the SmartStruxure servers. When used as a stationary HMI terminal, AD v2 is connected to a USB power adapter to ensure that its battery is charged.
AD v2
Hardware Overview
Connecting AD to AS-P or AS-B
Connecting AD to Automation Server and a Power Adapter
Connecting AD to a Power Adapter