You install the AD v2 tablet and the frame on the base to install AD v2 on a control cabinet or a wall and to provide the tablet with a protective frame.
Thread the USB cable through the hole in the cabinet or wall and through the center hole (cable grommet) in the base.
Route the cable from the center hole to the left side of the base.
Carefully insert the tablet into the base from above and then slide the tablet completely into the base.
Insert the USB cable into the tablet's charger/accessory port.
Fit the ribs inside the top of the frame to the base and hook the frame onto the base.
Push the frame onto the base.
Fit the security screws (M4 x 0.7 x 10 mm) to the screw inserts at the bottom of the frame and tighten the screws using a T20 Security TORX screwdriver or bit.
You can now make the required connections for power supply and communication with the automation servers.