You wire the terminal blocks installed on the MP-C to connect I/O devices and power.
De-energize the high-voltage equipment connected to the relay outputs of the controller.
This applies to all MP-C controllers except the MP-C-18B model, which does not have relay outputs.
Disconnect the 24 VAC/DC power supply and other electrically powered equipment that is connected to the controller.
Ensure that the correct terminal block is used and that it is properly installed on the MP-C. For more information, see Installing a Terminal Block on MP-C .
Loosen the screws of the terminal block.
Strip approximately 7 mm (0.3 inch) of the insulation from the end of each wire.
Insert the stripped end of each wire fully into its intended terminal. Ensure that no bare wire strands extend from the terminal.
Tighten the screws using a small flat-blade screwdriver. Ensure that the screws are fully tightened. Use the following recommended screw tightening torque: 0.56 Nm (5 lbf.in).