Log on to rate and give feedback
1
2
3
4
5
Log on to rate
0
Concept
Produits :
RP-C, RP-C-EXT-KNX
Fonctionnalités :
Matériel
Version produit :
3.2, 3.3, 2022, 2023, 2024
01/09/2020
KNX Modbus Gateway Programming Mode
When the KNX Modbus gateway (RP-C-EXT-KNX) is in programming mode, you can assign an individual address to the device on the KNX bus.
You put the KNX Modbus gateway in programming mode by either pressing the Programming button or pressing the KNX write and KNX read buttons at the same time. Pour plus d'informations, voir KNX Modbus Gateway Buttons .
When the device is in programming mode, the Programming LED and Mode LED are lit red. Pour plus d'informations, voir KNX Modbus Gateway LEDs .
If required, the KNX Modbus gateway can be reset to factory default settings. Pour plus d'informations, voir Performing a Factory Reset of the KNX Modbus Gateway .
Hardware Overview
KNX Modbus Gateway RP-C-EXT-KNX
KNX Modbus Gateway Buttons
KNX Modbus Gateway LEDs
Performing a Factory Reset of the KNX Modbus Gateway