Log on to rate and give feedback
1
2
3
4
5
Log on to rate
5
Concept
Products:
MP-V
Functionalities:
Hardware
Product version:
2022, 2023, 2024
9/11/2023
Differences Between MP-V Hardware Versions
There are few differences in hardware between different hardware versions of the MP-V models.
|
Hardware Feature |
Part Number a : SXWMPV7AX10002 and SXWMPV9AX10002 Hardware Version a : All |
Part Number a : SXWMPV7AX10001 and SXWMPV9AX10001 Hardware Version a : xx/21 and Later |
Part Number a : SXWMPV7AX10001 and SXWMPV9AX10001 Hardware Version a : Earlier than xx/21 |
|
RS-485 Com A port, BACnet MS/TP support |
no d |
no d e |
|
|
Air flow sensor |
Flow-through type f |
Flow-through type f |
Diaphragm based type |
- The part number and hardware version are shown on the label on the front of the MP-V controllers.
- The RS-485 Com A port on MP-V-7A and MP-V-9A controllers with part numbers SXWMPV7AX10002 and SXWMPV9AX10002 is prepared for BACnet MS/TP (RS-485) network communication through modified pin configuration. An RJ45 to screw terminal block adapter is required to connect the MP-V controller to the BACnet MS/TP network for communication with the AS-P or AS-B server. The adapter can be ordered from Schneider Electric. In addition, a Cat 5 (or higher) UTP cable with RJ45 connectors is required to connect the adapter. The recommended maximum cable length is 0.3 m (12 inches). The cable should be rated for the target environment. The cable is not included with the adapter but needs to be purchased separately.
- SXWMPV7AX10002 and SXWMPV9AX10002 are compatible with EcoStruxure Building Operation version 2.0.4 and later when the controller firmware is downgraded in the field to version 2.00.03.01203 and later. Version 4.0.x controller firmware from the factory is compatible with EcoStruxure Building Operation version 3.x.x and later. BACnet MS/TP support for SXWMPV7AX10002 and SXWMPV9AX10002 requires controller firmware version 4.0.2 and later and EcoStruxure Building Operation version 4.0.2 and later.
- The RS-485 Com A port on MP-V-7A and MP-V-9A controllers with part numbers SXWMPV7AX10001 and SXWMPV9AX10001 does not support BACnet MS/TP (RS-485) network communication, but is designed for and can only be used for the sensor bus.
- The RS-485 Com A port may be labeled “Sensor Bus” or “RS-485 Com A” on MP-V-7A and MP-V-9A controllers with part numbers SXWMPV7AX10001 and SXWMPV9AX10001 and hardware version xx/19 and earlier.
- The air flow sensor (pressure sensor) of flow-through type provides improved pressure reading stability, especially at low pressures and zero (0) pressure.
MP-V Controllers
MP-V Models
Air Flow Sensor