Log on to rate and give feedback    1 2 3 4 5 Log on to rate
Hardware Installation Hardware Installation 7/14/2022
Products: MP-V, RP-C
Functionalities: Hardware
Product version: 2022

SpaceLogic™ RS-485 Adapter

Regulatory Compliance and Safety Information

Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel. No responsibility is assumed by Schneider Electric for any consequences arising out of the use of this material.

Carefully read these instructions and all information relevant for this product before trying to install it. See the list of technical literature.

The technical literature and declarations of conformity can be accessed on the Schneider Electric extranet, ecoxpert.se.com. Contact your local Schneider Electric sales office for a hard copy of the documentation or for additional information.

Technical Literature

  • SpaceLogic Hardware Reference Guide, 04-XX001-XX-en

Supported MP-V, RP-C, and RP-V Controller Versions

  • MP-V part numbers: SXWMPV7AX10002, SXWMPV7AX10003, SXWMPV9AX10002, and SXWMPV9AX10003

  • RP-C part numbers: SXWRCF12A10002, SXWRCF12B10002, SXWRCF12C10002, SXWRCF16A10003, SXWRCF16B10001, and SXWRCF16B10002

  • RP-V part numbers: SXWRPV4A10001 and SXWRPV5A10001

Installing the Adapter

Connecting an Isolated RS-485 Adapter to an MP-V, RP-C, or RP-V Controller



For a BACnet MS/TP network with MNB BACnet devices, ensure you use an isolated RS-485 adapter (SXWISORS48510001) connected to the RP controller's Com B port or MP-V controller's Com A port.

Failure to follow these instructions can result in BACnet MS/TP network outage or performance degradation.

Connecting a Non-isolated RS-485 Adapter to an MP-V, RP-C, or RP-V Controller


Recommended screw tightening torque: 0.5 Nm (4.5 lbf.in)

For information on wiring, see the SpaceLogic Hardware Reference Guide.

Part Numbers


Part number

Isolated RS-485 adapter (cable not included)
Non-isolated RS-485 adapter (cable not included)
DC input
Nominal voltage
Isolated adapter: 24 VDC
Non-isolated adapter: 0 V
Maximum power consumption
Isolated adapter: 0.4 W
Non-isolated adapter: 0 W
To automation server
RS-485, 4-pole screw terminal block
To RP-C, RP-V, and MP-V controller
RS-485, RJ45 port
Operation environment
Ambient temperature, operating
0 to 50 °C (32 to 122 °F)
Indoor use only
Maximum 95 % RH non-condensing
Isolated adapter: 80 g (2.82 oz)
Non-isolated adapter: 40 g (1.41 oz)
Ingress protection rating
IP 20
Plastic flame rating
UL94 V-0
Plenum rating
UL 2043 (Approved for plenum installations)

Addendum - California Proposition 65 Warning Statement for California Residents

WARNING: This product can expose you to chemicals including lead which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

Community Content

Product version